Rep 10.21 Stripper Blade, Gate And Baffle - Xerox ColorQube 9303 Series Service Manual

3. Install the exit path, Figure 4.
3
Install the remaining screws
marked C in any order
1
Install screw A
Figure 4 Securing the exit path
4. Transfer the finisher docking actuator,
paper path assembly to the new exit paper path assembly.
Repairs/Adjustments
REP 10.20, REP 10.21
2
Install screw B
PL 12.100 Item 17, if present, from the old exit

REP 10.21 Stripper Blade, Gate and Baffle

Parts List on PL 10.12
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. The stripper blade is very sharp and can cause injury.
Do not clean the stripper blade. The stripper blade is very sharp and can cause injury. If
the stripper blade is dirty a new blade must be installed.
Use care when working near the drum. The drum can be damaged easily, which will cause
print quality defects.
1. Open the front door.
2. Remove the inner cover,
3. Open the stripper gate, GP
4. Remove the stripper blade retaining tool from the base of the machine, refer to
5. Use the stripper blade retaining tool to secure the stripper blade in the safe removal posi-
tion, Figure 1.
February 2013
4-92
WARNING
GP 14. Disconnect the power cord
WARNING
WARNING
CAUTION
PL 81.11 Item 2.
31.
ColorQube® 9303 Family
Figure 4.