7.
Figure
3. At the rear of the HVF, remove the input roll.
2
Slide the pulley and the
bush along the shaft.
Figure 3 Input roll removal.
Replacement
The replacement procedure is the reverse of the removal procedure.
Repairs/Adjustments
REP 12.40-171, REP 12.41-171
3
Lift the shaft and remove
the belt from the pulley.
4
Remove the pulley and
the bush.
5
Remove the input roll.
1
Remove the circlip.
REAR VIEW
REP 12.41-171 HVF Inserter Guide Roll
Parts List on
PL
12.130.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Remove the HVF front door,
2.
Remove the HVF top cover,
3.
Remove the HVF front cover,
4.
Remove the HVF rear cover,
5.
Open guide 8a.
6.
Figure
1. At the front of the HVF, remove the circlip and the bush.
Figure 1 Circlip and bush removal.
February 2013
4-178
WARNING
WARNING
GP
14. Disconnect the power cord from the cus-
REP
12.1-171.
REP
12.1-171.
REP
12.1-171.
REP
12.1-171.
1
Remove the circlip
and the bush.
ColorQube® 9303 Family