Xerox ColorQube 9303 Series Service Manual page 1161

4
Tighten the two screws alternately a little at a time, while
holding the free screw with a finger. Ensure that the anvil
does not move as the screws are tightened.
6. Open the stapler fully by use of the stapler gear,
7. Perform the adjustment on the other stapler anvil if necessary.
ColorQube® 9303 Family
Figure 3 Closing the stapler
Figure 3, then remove the alignment tool.
February 2013
Spacer
1
Rotate the stapler gear counterclockwise
to begin closing the stapler.
3
Continue to rotate the stapler gear
until the anvil is tightly clamped by
the alignment tool and the stapler
will close no further.
8. Check the operation of the stapler by making a few stapled sets using 2 sheets of 80gsm
(20 pound) paper. check the quality of the staple clinch.
4-403
2
Continue to rotate the
stapler gear so that the
two protrusions on the
tool engage with the
depressions in the
anvil. Move the anvil if
necessary using the
two clamp screws.
Anvil
Clamp plate
Repairs/Adjustments
ADJ 12.3-171