Xerox ColorQube 9303 Series Service Manual page 803

3. Remove the drive assembly, Figure
3
Remove the drive assembly.
Figure 2 Drives assembly
ColorQube® 9303 Family
2.
1
Release the tension and
disengage the drive
belts.
2
Release the harness.
4. Remove the duplex solenoid,
3
Disconnect PJ205.
4
Disconnect the ground harness.
Replacement
The screw that attaches the ground harness to the duplex solenoid is shorter than the other
screws. Do not use the incorrect screw.
1. The replacement is the reverse of the removal procedure. Make sure that the wiring is not
caught below the drive assembly.
2. Perform the DADH motor adjustment,
February 2013
4-45
Figure 3.
2
Remove the screw.
1
Disconnect the
link arm.
5
Release the duplex sole-
noid from the clips.
Figure 3 Duplex solenoid
CAUTION
ADJ 5.1.
Repairs/Adjustments
REP 5.7