Rep 73.4 Tray 3 Stack Height Sensor; Rep 73.5 Tray 3 Home Sensor - Xerox ColorQube 9303 Series Service Manual

REP 73.4 Tray 3 Stack Height Sensor

Parts List on PL 81.30
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Pull out tray 3.
2. Remove Tray 3 paper feed assembly,
3. Disconnect and remove the stack height sensor,
2
1
Press the tabs to release the sensor.
Disconnect the harness
Figure 1 Stack height sensor
Replacement
The replacement is the reverse of the removal procedure.
ColorQube® 9303 Family
WARNING
GP 14. Disconnect the power cord
WARNING
REP 81.2.
Figure 1.

REP 73.5 Tray 3 Home Sensor

Parts List on PL 73.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
The removal procedure is the same for tray 3 and tray 4.
1. Pull out Tray 3
2. Remove the right side cover,
3. Remove the tray 3 home sensor and holder,
Figure 1 Tray home switch and holder
Replacement
Replacement is the reverse of the removal procedure.
February 2013
4-269
WARNING
GP 14. Disconnect the power cord
WARNING
PL 70.25 Item 4.
Figure 1.
1
Disconnect the
harness
2
Remove screw
Repairs/Adjustments
REP 73.4, REP 73.5