Rep 12.10-110 Ejector Assembly Sensors - Xerox ColorQube 9303 Series Service Manual

3. Remove the staple head unit from the stapling unit
A
2
Disconnect the
harnesses.
3
Remove the staple head unit.
Figure 1 Removing the staple head unit
Replacement
Reverse the removal procedure to replace the staple head unit.
ColorQube® 9303 Family
Figure 1.
A
A
1
Remove 4 screws
marked A then
remove the stapler
cover.
A

REP 12.10-110 Ejector Assembly Sensors

Parts List on PL 12.50.
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
Take care not to topple the LCSS. The LCSS is unstable when un-docked from the
machine. Do not show the customer how to un-dock the LCSS.
1. Disconnect the two harnesses between the LCSS and the machine.
2. Un-dock the LCSS, REP 12.13-110
3. Ensure the stapling unit is at the home position.
4. If necessary, manually move the ejector to the left position.
February 2013
4-111
WARNING
GP 14. Disconnect the power cord
WARNING
WARNING
and move it away from the machine.
Repairs/Adjustments
REP 12.9-110, REP 12.10-110