Rep 62.7 Scan Cables - Xerox ColorQube 9303 Series Service Manual

REP 62.7 Scan Cables

Parts List on PL 62.16
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the scan carriage, REP 62.5.
2. Remove the scan motor cover, (2 screws).
3. Slide the cables off the pulleys or capstan.
4. Remove the springs and lift out the cables.
Replacement
1. Figure 1 shows the general arrangement of the scan cables, when correctly installed.
Lower scan cable.
Note that the springs are in
the same relative position.
Figure 1 Scan cable arrangement
ColorQube® 9303 Family
WARNING
GP 14. Disconnect the power cord
WARNING
6 turns on
each cable.
Upper scan
cable.
2. Figure 2. Prepare to install the lower scan cable.
NOTE: The lower scan cable is black and is longer than the upper scan cable.
NOTE: The anchor ball is not installed centrally on the scan cables.
NOTE: To assist in holding the scan cables in position, use adhesive tape.
short end.
3
Use adhesive tape to secure the anchor ball in the anchor point.
Figure 2 Mount lower scan cable on the capstan
February 2013
4-251
long end.
longer, black cable.
2
Wind three turns below the anchor
point on the capstan.
1
Install the anchor ball in the anchor
point.
Repairs/Adjustments
REP 62.7