Table of Contents
Advertisement
2.
Remove the reverse roller and coupling from the reverse roller shaft,
For clarity the top
cover is not shown.
2
3
Remove the clip.
Remove the reverse feed roller.
Figure 2 Reverse roller removal
Replacement
1.
Reverse the removal procedure to replace the reverse and the pickup roller assemblies.
2.
After replacing the pickup roller assembly close the Inserter top cover fully to engage the
link arm with the pickup roller.
3.
If a new inserter pickup assembly is installed, reset the inserter feed count to zero. Refer
to
dC135
CRU / HFSI Status.
Repairs/Adjustments
REP 12.95-171, REP 12.96-171
Figure
2.
REP 12.96-171 HVF Fixed and Adjustable Casters
Parts List on
1
Removal
Release the tab
then remove the
retard cover.
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Do not remove more than one caster at a time unless the HVF frame is properly supported and
stable.
1.
Undock the Tri Folder from the HVF,
2.
Undock the HVF from the copier and remove the HVF front and rear covers,
171.
3.
Get help to lift and support the HVF frame securely at a position close to where the caster
is to be removed,
reams of paper) above the floor so that the caster is not supporting the unit.
February 2013
4-236
PL
12.100.
WARNING
WARNING
GP
CAUTION
REP
12.82-171.
GP
16. Support the frame approximately 4 inches (approximately 2
14. Disconnect the power cord
REP 12.1-
ColorQube® 9303 Family
Advertisement
Chapters
Table of Contents
