Pvc Attributes - Bay Networks NauticaRS Reference Manual

Parameter:
MTC:
Default:
Options:
Function:
Instructions:
117237-E Rev.00
ext-modem
ex
none
none, dtr, at
If DTR is set here then the modem will call a
pre-programmed internal number. If AT is selected then
the user will set the number to be called using the AT
command set.
Select the type of modem you are using; refer to the
modem's documentation if you are unsure.

PVC Attributes

Once a WAN's mode has been changed to FrameRelaySync,
PVCs can be created for the WAN.
To create a PVC manually, use the following syntax:
[co] [new] dev pvc/pvc
where co takes the router into config mode (if required), new is
the new verb, dev takes the BCC into the device object and pvc/
pvc is the command to create the new permanent virtual circuit.
When enter is pressed, the PVC is created and numbered
automatically; the command line moves directly into the PVC for
editing:
Note: This is the only time a PVC can be edited; it cannot be
altered once it has been created.
Once created, you move into the pvc object:
device/pvc/pvc01#
Nautica Devices
6-75