Frame Relay Wan Attributes - Bay Networks NauticaRS Reference Manual

Nortel nautica nauticars software: reference guide

Hide thumbs Also See for NauticaRS:

Table of Contents

NauticaRS 5.5R Reference Guide

Frame Relay WAN Attributes

To edit a WAN device, use the following syntax:

[co] [mod] dev wan/wan01

where co takes the router into config mode (if required), mod is

the MTD for the modify verb, dev takes the router into the device

object, wan is the device type and wan01 is the number of the

WAN device being edited.

To change the mode of a WAN to Frame Relay, edit the WAN and

change the following attribute:

device/wan/wan01/ mode framerelaysync

where mode is the parameter and framerelaysync is the new

value for the attribute.

Changing the mode to framerelaysync allows the automatic and

manual creation of Permanent Virtual Circuits (PVCs). For

information on how to create and amend PVCs, refer to

When the mode of the WAN card is changed to framerelaysync,

more options become available for the WAN.

In the table below, click on the parameter for which you require

further assistance.

autopvclearn

117237-E Rev.00

Nauticars 5.5r