Fractional Mode - Bay Networks NauticaRS Reference Manual

Nautica Devices

Fractional Mode

To edit a PRI device, use the following syntax:
[co] [mod] dev pri/isdn-01
where co takes you into config mode (if required), mod is the
MTD for the modify verb, dev takes you to the device object, pri
is the device type and isdn-pri01 is the number of the PRI device
being edited.
The BCC prompt changes to show that you are editing the PRI
device:
device/pri/ISDN-PRI01#
To change the PRI card from PRI mode to Fractional mode, at the
PRI prompt, type the following:
device/pri/ISDN-PRI01# mode frac
Where mode is the mode parameter and frac changes the mode
to Fractional. For more information on the mode attribute, refer to
page 6-50.
Typing i at this prompt lists all the attributes for the device.
In the table below, click on the parameter for which you require
further assistance.
117237-E Rev.00 6-45