The BRI Device
117237-E Rev.00
Basic Rate ISDN (BRI) ports allow access to ISDN. Each BRI
device gives you two channels. To edit a BRI device, use the
following syntax:
[co] [mod] dev bri/isdn-tann
where co is the MTC to move you into config mode (if required);
mod is the MTC for the modify command (optional); dev moves
you to the device object; bri is the device type and isdn-tann is
the name of the BRI port, for example isdn-ta01.
When you have entered the BRI object, the prompt changes to
show that you are in the device object, for example:
device/bri/isdn-ta01#
Typing i (MTD for the info command) at this prompt lists all the
parameters for the device.
In the table below, click on the parameter for which you require
further assistance.
type
ident
state
tei
Use-CLI
clipmode
ton
npi
msn
subaddress
Nautica Devices
outside-line
mode
incomingres
outgoingres
Switch Type
Ch1s
&
Ch2s
Ch1L
&
Ch2L
areacode
voice-spid
PPP-Profile
6-19