Editing A Remote Path - Bay Networks NauticaRS Reference Manual

NauticaRS 5.5R Reference Guide
path/ppp/RemotePPPSite#
3-16
Note: In this example, the number of devices has been reduced.
You will have more devices and may need to page through the
options until you can see the paths. Follow the prompts on the
screen to move down through the lists.
The devices shown here represent the physical cards or ports in
the Nautica 4000. The eth/LAN01 path is the default path to your
local network. The ppp/RemotePPPSite path is the path that is
used to reach the ISDN number specified during the Setup
procedure using PPP. The nau/Central path is the path that is used
to reach the ISDN number specified during the Setup procedure if
you have not consented to using PPP.

Editing a Remote Path

Remember, the RemotePPPSite and Central paths used in the
prior example may change their names when the Setup procedure
places an automatic call to them.
To edit a path, use the following MTC:
mod pa type/name
Where is the MTD for the verb modify (Appendix A),
mod
the MTD that takes you into the path context (Chapter 7),
the type of path to be edited and
this path.
For example, to edit the RemotePPPSite Path, type:
box# mod pa ppp/RemotePPPSite
The prompt will change to show that you are now in the path
object:
name is the name assigned to
117237-E Rev.00
is
pa
type is