Asynchronous Wan Attributes - Bay Networks NauticaRS Reference Manual

Parameter:
MTC:
Default:
Options:
Function:
Instructions:
117237-E Rev.00
autopvclearn
au
noautolearn
noautolearn, newpvcs, allpvcs
Allows incoming frames to create a Permanent Virtual
Circuit (PVC) automatically. The options are
NoAutoLearn (secure operation), NewPVCs (PVCs
notified by the frame relay local management interface if
Management Type is set), and AllPVCs (an entry is
created for all incoming PVCs, and for those received
from the local management interface).
For more information on PVCs, refer to
Select the PVC creation option.

Asynchronous WAN Attributes

To edit a WAN device, use the following syntax:
[co] [mod] dev wan/wan01
where co takes the router into config mode, mod is the modify
verb, dev takes the router into the device object, wan is the device
type and wan01 is the number of the WAN device being edited.
To change the mode of a WAN to Async, edit the WAN and
change the following attributes in the order shown here:
device/wan/wan01# speed 9600
device/wan/wan01# mode async
where speed and mode are the parameters and
are the new values for these parameters.
It is necessary to bring the speed down from 64000, as in
asynchronous mode, the local manager is also running at this
speed and the unit will become confused.
Nautica Devices
page 6-75.
and
async 9600
6-69