Setting Up Ipsec; Figure 20-2. About Nautica Wizard Window; Figure 20-3. Ipsec Tunnel Using Nat - Bay Networks NauticaRS Reference Manual

NauticaRS 5.5R Reference Guide

Setting up IPSec

Figure 20-3.
20-12
To show the version of Nautica Wizard, click on Help >
About Nautica Wizard. The About Nautica Wizard window
appears:
Figure 20-2.
IPSec requires that the public addresses of BOTH ends of the
tunnel MUST be known at configuration time. This precludes the
use of IPSec on a dial up link to an ISP where the IP address is
dynamically allocated.
If this functionality is required it is recommended that NAT be
used with the IPSec client running on the PC of the user. When
configuring IPSec using NAT, the IP address of the originating
router must be known first. A PPP path is then set up to the ISP
along with a default route. An IPSec tunnel is then created from
the originating router to the destination switch or router.
IPSec Tunnel Using NAT
About Nautica Wizard window
117237-E Rev.00