Configuring The Cpe Router Frame Relay Connection With Ipx - Bay Networks Baystream 7 Configuration And Troubleshooting Manual

Configuring the CPE Router Frame Relay Connection with IPX
Configure the COM1 serial link to the frame relay cloud exactly the same way,
except that the network number for that interface is 0x0000ABCDEF and the
encapsulation type for that link is SNAP. The following steps describe the process.
1.
2.
3.
4.
5.
6.
7.
This completes the CPE router Ethernet and Serial interface configuration for
IPX.
115623B Rev. 00
From the Site Manager window, use the Tools menu to select
Configuration Manager in dynamic mode.
The path is Site Manager > Tools > Configuration Manager > Dynamic.
Click the interface that you want to configure.
This example configures frame relay on the circuit designated COM1. The
Edit Connector window appears.
Click Edit Circuit.
The frame relay Circuit Definition window appears.
Click Services.
The frame relay Service list window appears.
From the Protocols menu, select Add/Delete.
Click the check boxes for the IPX and RIP/SAP protocols, then click OK.
The Frame relay Service List window reappears.
Enter your Novell Configured Network Number in hexadecimal format,
then make sure that the Configured Encapsulation parameter is correctly
set for that interface and click OK.
BayStream Multiservice Software Version 7.2
Configuring IPX as the Routing Protocol
8-7