Nortel CallPilot Administrator's Manual page 238

238 Chapter 12 Monitoring the CallPilot server and resources
•
Getting there: System → Alarm Monitor
Filtering SNMP traps
Access the SNMP Settings screen from the Alarm Monitor to determine
which SNMP traps, based on severity, are sent out from CallPilot.
Clearing active alarms
Clear alarms from the Alarm Monitor in one of two ways:
•
•
Configuring SNMP on the CallPilot server
This section describes how to configure the CallPilot server to send Simple
Network Management Protocol (SNMP) traps to a Network Management
System (NMS). When this service is configured you can work with server
alarms on an NMS.
Two examples of NMS clients that you can configure to use this service are
the OTM Alarm Notification and the HP Openview tools. The procedure in
this section uses the OTM Alarm Notification tool as one example of how
to configure an NMS.
The configuration has two parts:
1. Configuring SNMP on the CallPilot server so that the traps are directed
2. Configuring the NMS so that it can receive the CallPilot SNMP traps.
Configuring SNMP Agent Information
Step
1
2
3
Copyright © 2007, Nortel Networks
.
Alarms can be cleared from the Alarm Monitor, but the event that
generated the alarm is not cleared from the event log or the Event
Browser.
The CallPilot server automatically clears alarms when the alarm
condition changes.
You can clear alarms manually.
When you clear an alarm you remove the selected alarm (but not the
event that raised it) from the list shown in the Alarm Monitor. The event
that generated the alarm can still be viewed in the Event Browser. If the
event occurs again, however, the alarm reappears in the Alarm Monitor.
to an NMS.
Action
Click Start > Settings > Control Panel > Administrative Tools,
and then click Computer Management.
In the console tree, expand Services and Applications, and then
click Services.
In the right pane, double-click SNMP Service.
Nortel CallPilot
Administrator Guide
NN44200-601 01.11 Standard
5.0 9 November 2007