Subaru S209 2019 Service Manual page 233

(3) Prepare a stopper by wrapping a cloth adhesive tape, etc. around the drill bit at the position 5 mm (0.2
in) from the tip end.
CAUTION:
Be sure to prepare a stopper; otherwise, the drill may interfere with the spoiler assembly - side and
cause damage.
(a) 5 mm (0.2 in)
(4) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (b) using a drill (a), and then
make a pilot hole of 6 mm (0.24 in) diameter.
(b)
(5) Make a hole of 9.5 mm (0.37 in) diameter (a) and a hole of 10 mm (0.39 in) diameter (b) at the loca-
tions shown in the figure below.
CAUTION:
• Be sure to make a hole of a specified diameter. The side under spoiler may not be installed if the
hole diameter is large.
Side Garnish & Side Spoiler
(a)
(b) Drill bit
(b) (b) (b) (b)
(b)
(c)
(b) (b) (b) (b)
(a)
EI-45
EXTERIOR/INTERIOR TRIM
AA-10027
(c) Adhesive tape
(b) (b)
Ft
AA-10028