Subaru S209 2019 Service Manual page 107

Tightening torque:
155 N·m (15.8 kgf-m, 114.3 ft-lb)
NOTE:
While holding the adjusting bolt side, tighten the nut side.
2. ADJUSTMENT OF DIFFERENCE BETWEEN RIGHT AND LEFT STEERING ANGLES
1) Operate the steering system from lock to lock and stop operating it at the center position from lock to lock,
and then install the steering wheel in the straight-ahead position.
NOTE:
Using of the steering wheel angle sensor output values shown on Subaru Select Monitor will facilitate your
work.
2) Before adjusting toe-in, be sure to adjust the steering wheel in the straight-ahead position (steering angle
sensor output: 0 deg).
3. FRONT WHEEL TOE-IN
When adjusting the toe-in, adjust it to the following value.
Toe-in: Adjustment value

OUT 2 2 mm (OUT 0.08
1) Check that the left and right wheel steering angles are within specification.
2) Loosen the left and right side steering tie-rod lock nuts (a).
3) Turn the left and right tie-rods by equal amounts until the toe-in is at the specification.
NOTE:
Both the left and right tie-rods are right-hand threaded. To increase toe-in, turn both tie-rods clockwise by
equal amount (viewing from the inside of vehicle).
4) Tighten the tie-rod lock nut (a).
Tightening torque:
85 N·m (8.7 kgf-m, 62.7 ft-lb)
5) Check and correct the tie-rod boot if twisted.
4. REAR WHEEL TOE-IN
When adjusting, adjust it to the following value.
Toe-in: Adjustment value
 
0 2 mm (0 0.08 in)
Wheel Alignment

0.08 in)
FS-13
FRONT SUSPENSION
(a)
FS-10117