Subaru S209 2019 Service Manual page 36

INTAKE (INDUCTION)
(1) Intercooler water spray tank ASSY
(2) Intercooler water spray relay
(3) Intercooler water spray tank
bracket
(4) Intercooler water spray timer
(5) Intercooler water spray motor
(6) BRKT UPR TANK
(7) PLATE LWR ASSY
(8) Intercooler water spray side hose
ASSY
(9) JOINT I
*When installing a new intercooler water spray duct hose, refer to the Notes in the installation procedure of intercooler water
spray hose.
C: CAUTION
• Prior to starting work, pay special attention to the following:
1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective
goggles, etc. if necessary.
2. Protect the vehicle using a seat cover, fender cover, etc.
3. Prepare the service tools, clean cloth, containers to catch grease and oil, etc.
• Vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated
parts.
• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and
replacement.
• Before disconnecting connectors of sensors or units, be sure to disconnect the ground cable from battery.
• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.
• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.
• Keep the removed parts in order and protect them from dust and dirt.
• All removed parts, if to be reused, should be reinstalled in the original positions with attention to the correct
directions, etc.
• Bolts, nuts and washers should be replaced with new parts as required.
• Be sure to tighten the fasteners including bolts and nuts to the specified torque.
D: PREPARATION TOOL
1. GENERAL TOOL
TOOL NAME
Circuit tester
Mighty Vac
Steering wheel puller
Squeegee
General Description
(10) Clip
(11) Intercooler water spray front hose
ASSY
(12) VALVE F
(13) Intercooler water spray duct hose
(14) JOINT Y
(15) Intercooler water spray duct hose
(16) Intercooler water spray duct hose
(17) DUCT SEAL BRKT
(18) NOZZLE BRKT
Used for measuring resistance and voltage.
Used for checking waste gate actuator and air by-pass valve.
Used for removing the steering wheel.
Used for applying an I/C SPRAY SW LABEL.
IN-6
(19) JOINT L
(20) NOZZLE HOSE
(21) Intercooler water spray nozzle
Tightening torque: N·m (kgf-m, ft-lb)
T1: 4.5 (0.5, 3.3)
T2: 7.5 (0.8, 5.5)
T3: 18 (1.8, 13.3)
REMARKS