(7) Insert the well nut (b) at the position (a) shown in the figure.
(a)
2) Clean and degrease the side under spoiler attachment area on the spoiler assembly - side.
NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of double-sided tape and the at-
tachment area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
• Heating a particular small area will cause deformation of the parts.
3) Install the side under spoiler to the spoiler assembly - side.
(1) Peel off 38.5 mm (1.52 in) of the backing sheet (b) on the side under spoiler (a) in the direction of the
arrow.
Side Garnish & Side Spoiler
Ft
(b)
(a)
EI-47
x10
(b)
Ft
EXTERIOR/INTERIOR TRIM
Ft
AA-10031
AA-10012