Subaru S209 2019 Service Manual page 246

EXTERIOR/INTERIOR TRIM
• When drilling a hole, make a through-hole to the rear quarter outer and the arch rear inner.
(e)
(a) Outer side
(b) Inner side
(11) Smoothen the area around the drilled hole with a sandpaper.
CAUTION:
Remove any burrs on the rear quarter outer and the arch rear inner to avoid damaging the vehicle.
(12) Clean and degrease the peripheral area around the drilled hole (a) completely, using cloth with de-
greasing agent.
(13) Apply EPICON primer or equivalent to the drilled hole edge and its peripheral area.
Side Garnish & Side Spoiler
(c) (d)
A-A
A
A
(f)
(a)
(c) Rear quarter outer
(d) Arch rear inner
(a)
EI-58
(f)
(b)
AA-10052
(e) Drill
(f) Mark-off line position
(a)
AA-10053