Subaru S209 2019 Service Manual page 205

(4) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (a) using a drill, and then
make a pilot hole of 6 mm (0.24 in) diameter.
(5) Make a hole of 10 mm (0.39 in) diameter (a) and a hole of 12 mm (0.47 in) diameter (b) at the locations
shown in the figure.
CAUTION:
Be sure to make a hole of a specified diameter. The front bumper extension may not be installed if the
hole diameter is large.
2) Perform the work for installing the front under spoiler.
(1) Attach the pattern paper (a) along the parting line (c) of the bumper face - front (b).
Front Bumper
EI-17
EXTERIOR/INTERIOR TRIM
(a)
AA-10042
(a)
(b)
AA-10043