Subaru S209 2019 Service Manual page 225

• Confirm that the molding (f) of the rear quarter spoiler (a) is not caught in and deformed.
(c)
(b)
1
(a) Rear quarter spoiler
(b) Backing sheet
(7) Press-fit the rear quarter spoiler.
(8) Tighten the screws temporarily installed in step (3).
7) Remove the bumper face - rear.
8) Clean and degrease the rear bumper extension attachment area on the bumper face - rear.
NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of double-sided tape and the at-
tachment area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
• Heating a particular small area will cause deformation of the parts.
9) Install the rear bumper extension.
(1) Peel off 38.5 mm (1.52 in) of the backing sheets (b) on the rear bumper extension (a).
(2) Install the rear bumper extension with nut (a).
Rear Bumper
A
(c)
A
(b)
2
(c) Direction of peeling off the backing
paper
(d) Bumper face - rear
(b)
(b)
(b)
EI-37
OK NG
(d)
(d)
(e)
(f)
(a)
A-A
(e) Opening
(f) Molding
(a)
EXTERIOR/INTERIOR TRIM
(f)
(a)
AA-10078
AA-10085