Subaru S209 2019 Service Manual page 48

Turbocharger
INTAKE (INDUCTION)
5) After inspection, install the related parts in the reverse order of removal.
NOTE:
• After installing the vacuum hose, make sure that the clearance (A) between the strut tower bar and the vac-
uum hose is 15 mm (0.591 in) or more.
• When replacing the tie-wrap (a) with a new part, use HellermannTyton GalvaLok GL150 or equivalent.
(A)
(a)
AA-13045
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
2. OTHER INSPECTIONS
1) Check that the turbocharger, turbocharger stay and pipe have no deformation, cracks or other damages.
2) Check that the hose and intake duct have no cracks, damage or loose part.
3) Check that there are no oil leakage or water leakage from the pipe attachment section.
IN-18