NOTE:
While holding the adjusting bolt side, tighten the nut side.
5. THRUST ANGLE
When adjusting, adjust it to the following value.
Thrust angle: Adjustment value
0°
20
Less than 20
when "L" is 15 mm (0.6 in) or less
(a)
Center line of loci (front axle)
1) Make thrust angle adjustments by turning the toe-in adjusting bolts of the rear suspension equally in the
same direction.
2) When one rear wheel is adjusted in a toe-in direction, adjust the other rear wheel equally in toe-out direc-
tion, in order to make the thrust angle adjustment.
3) When the left and right adjusting bolts are turned by one graduation, the thrust angle will change approx.
15. ("L" is approx. 11 mm (0.43 in).)
NOTE:
Thrust angle is a mean value of left and right wheel toe angles in relation to the vehicle body center line.
Wheel Alignment
(b)
(a)
(b)
Center line of loci (rear axle)
FS-15
FRONT SUSPENSION
L
FS-00658