Subaru S209 2019 Service Manual page 102

FRONT SUSPENSION
NOTE:
Empty the trunk or luggage room, load the spare tire, jack and service tools, and fill up the fuel tank.
3) Set the steering wheel in a straight-ahead position, and stabilize the suspension by moving the vehicle in
a straight line for 5 m (16 ft) or more.
4) Suspend a thread from the wheel arch (point "A" in the figure below) and affix at a position directly above
the center of wheel.
5) Measure the distance between the point "A" and the center of wheel.
(2)
(4)
(4)
(1) Wheel arch height
(2) Front fender
(3) Rear quarter
Tire size
265/35R19
2. CAMBER
1) Place the front wheel on the turning radius gauge.
NOTE:
Make sure the ground contact surfaces of the front and rear wheels are at the same height.
Wheel Alignment
A
(4) Front wheel arch height
(5) Rear wheel arch height
(6) Flange bend line
359 (14.13)
FS-8
(3)
A
(5)
(7)
(8)
Wheel arch height specification mm (in)
+12 mm
(Tolerance:
–24 mm
Front
A
(6)
(7)
(1)
(5)
(8)
Point of measurement
End of spindle
+0.47 in
( ))
–0.94 in
Rear
351 (13.82)
FS-00655