Subaru S209 2019 Service Manual page 79

General Description
CONTROL SYSTEMS
C: CAUTION
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-
stallation, disassembly and replacement.
• Use SUBARU genuine fluid, grease etc. or equivalent. Do not mix fluid, grease, etc. of different grades or
manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Apply grease onto sliding or revolving surfaces before installation.
• Before installing O-rings or snap rings, apply a proper amount of grease to avoid damage and deformation.
• Before securing a part in a vise, place cushioning material such as wood blocks, aluminum plate or cloth
between the part and the vise.
• Before disconnecting electrical connectors, be sure to disconnect the negative terminal from battery.
CS-3