Subaru S209 2019 Service Manual page 50

INTAKE (INDUCTION)
B: INSTALLATION
1) When using a new intercooler water spray tank
assembly, remove the unnecessary bracket (a).
2) Securely insert the washer part (a) on the rear
side of the BRKT UPR TANK into the grommet hole
so that it catches the bolt (b) of the PLATE LWR
ASSY, and temporarily tighten it with nuts.
(a)
(b)
3) Install the ground terminal, and tighten the nuts
temporarily installed in step 2).
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
4) Install the intercooler water spray relay.
5) Install the intercooler water spray timer.
Tightening torque:
4.5 N·m (0.5 kgf-m, 3.3 ft-lb)
6) Thereafter, install in the reverse order of remov-
al.
Intercooler Water Spray Tank & Motor
(a)
AA-14022
(a)
(b)
AA-14037
Tightening torque:
T1: 4.5 N·m (0.5 kgf-m, 3.3 ft-lb)
T2: 7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
C: INSPECTION
1. INTERCOOLER WATER SPRAY MOTOR
1) Check that the intercooler water spray motor has
no deformation, cracks or other damages.
2) Connect the battery positive terminal to terminal
No. 2 and the battery ground terminal to terminal
No. 1, and inspect the intercooler water spray mo-
tor operation.
CAUTION:
Do not run the intercooler water spray motor for
a long time under non-load condition.
2. OTHER INSPECTIONS
1) Check that the intercooler water spray tank as-
sembly has no deformation, cracks or other dam-
ages.
2) Check that the hose has no cracks, damage or
loose part.
IN-20
T2
T1
AA-14028
IN-02817