Intercooler Water Spray Switch
INTAKE (INDUCTION)
5) Remove the screw, disconnect the connector and remove the intercooler water spray switch.
PS-01719
B: INSTALLATION
CAUTION:
• Before handling the airbag system components, refer to "CAUTION" of "General Description" in
"AIRBAG SYSTEM".
• If the steering wheel has been removed, make sure that the steering roll connector is not turned
from the original position.
• If the steering wheel and steering angle sensor are removed, perform "VSC(VDC) Centering Mode"
of the VDC.
• Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper
installation.
NOTE:
• When installing a new intercooler water spray switch, perform the following steps.
• Perform the procedures for the left side in the same way as for the right side.
1) Clean and degrease the I/C SPRAY SW LABEL application area.
NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of I/C SPRAY SW LABEL and
its application area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
• Heating a particular small area will cause deformation of the parts.
2) Peel off a backing sheet of I/C SPRAY SW LABEL.
IN-32