Subaru S209 2019 Service Manual page 243

(5) Pass the tie-wrap (c) of the garnish assembly - fender (b) to the molding garnish (a).
CAUTION:
Be careful not to let the tie-wrap come off.
(a)
(b)
(6) Tighten the tie-wrap (a), and cut the excess part.
CAUTION:
Cut it so that the tie-wrap does not come out from the emblem application position.
4) Install the garnish assembly - fender on the front fender.
CAUTION:
Confirm that there are no cracks on the vehicle body installation clips or deformations on the garnish
assembly - fender.
5) Install the S209 emblem.
(1) Clean and degrease the S209 emblem attachment area on the molding garnish.
NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of double-sided tape and the at-
tachment area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
• Heating a particular small area will cause deformation of the parts.
(2) Peel off the backing sheet of the S209 emblem.
Side Garnish & Side Spoiler
(c)
A
(a)
A
EI-55
EXTERIOR/INTERIOR TRIM
(c)
AA-10081
(a)
A-A
AA-10083