Subaru S209 2019 Service Manual page 221

(7) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (a) using a drill, and then
make a pilot hole of 6 mm (0.24 in) diameter.
(8) Make a hole of 12 mm (0.47 in) diameter at the position (a) where the pilot hole is created using a drill.
CAUTION:
Be sure to make a hole of a specified diameter. The rear bumper extension may not be installed if the
hole diameter is large.
4) Install the bumper face - rear.
5) Clean and degrease the rear quarter spoiler attachment area (a) on the bumper face - rear.
NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of double-sided tape and the at-
tachment area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
Rear Bumper
(a)
(a)
EI-33
EXTERIOR/INTERIOR TRIM
AA-10069
AA-10099