Subaru S209 2019 Service Manual page 257

NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of double-sided tape and the at-
tachment area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
• Heating a particular small area will cause deformation of the parts.
2) Attach the side sill plate - front.
(1) Apply masking tape (c) to a position at 100 mm (3.94 in) (b) away from the rear end of the cover side
sill - front INN (a) toward the front side of the vehicle.
(2) Attach the backing sheet (d) on vehicle inside and the backing sheet (e) on vehicle outside to the front
side with masking tape (c).
NOTE:
To facilitate the work, peel off approx. 80 mm (3.15 in) of the backing sheet (d) on vehicle inside and attach
it to the front side. And then peel off approx. 50 mm (1.97 in) of the backing sheet (e) on vehicle outside and
attach it to the front side.
(a)
(d)
(A) 80 mm (3.15 in)
(a) Back side
(b) Front side
Lower Inner Trim
(b)
(b)
(A)
(B)
(e)
(B) 50 mm (1.97 in)
(c) Masking tape
(d) Backing sheet on vehicle inside
EI-69
EXTERIOR/INTERIOR TRIM
(a)
(c)
(c)
(e) (d)
(e) Backing sheet on vehicle outside
Ft
AA-10128
AA-10129