Subaru S209 2019 Service Manual page 208

EXTERIOR/INTERIOR TRIM
(6) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (d) using a drill (c), and then
make a pilot hole of 7 mm (0.28 in) diameter.
(a)
(a) Bumper face - front
(b) Inner parts
(7) Make a hole of 9.5 mm (0.37 in) at the position (b) where the pilot hole is created using a drill (a).
CAUTION:
Be sure to make a hole of a specified diameter. The front under spoiler may not be installed if the hole
diameter is large.
(8) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (b) using a drill (a), and then
make a hole of 6 mm (0.24 in) diameter.
CAUTION:
• Operate the steering wheel so that the drill does not interfere with tires.
Front Bumper
UP
(b)
Ft
(c)
(c) Drill
(b)
(b) (b)
(a)
EI-20
(d)
(d)
(a) (d)
RH
(c)
(d) Mark-off line position
Ft UP
RH
(b)
(b)
(b)
(b)
Ft UP
LH
(d)
(d)
(d)
(d)
AA-10045
LH
AA-10046