EXTERIOR/INTERIOR TRIM
4) Set the rear spoiler assembly to the trunk lid, and install the nut (b) to the upper side stud bolt (a) to tem-
porarily install the reinforcement rear (c).
5) Adjust so that the center of the bolt (b) is aligned to the center of a 10 mm (0.39 in) diameter (a) on the low-
er side.
NOTE:
Align the center positions on the left and right sides at the same time.
6) Tighten the nuts temporarily installed in step 4) to temporarily fix the rear spoiler assembly.
Rear Spoiler
(c)
(b)
(a)
(b)
(a)
EI-66
AA-10023
AA-10024