CONTROL SYSTEMS
Tightening torque:
T1: 12 N·m (1.2 kgf-m, 8.9 ft-lb)
T2: 32 N·m (3.3 kgf-m, 23.6 ft-lb)
(A)
Reverse check cable
4) Install the reverse check cable, washer and snap pin.
NOTE:
Pay attention to the installing direction of the snap ring.
(A)
Reverse check cable
(B)
Washer
5) Make sure the hole of extension case is aligned with that of reverse check lever. If the hole positions are
not aligned, adjust the reverse check cable.
NOTE:
• Check that the M3 bolt goes through the hole of reverse check lever and can be inserted into the hole of
extension case.
MT Gear Shift Lever
(A)
T1
T2
(D)
(B)
(C)
Snap pin
CS-8
(C)
(A)
(D)
Front side
CS-01791
CS-01792