Subaru S209 2019 Service Manual page 104

FRONT SUSPENSION
5. FRONT WHEEL TOE-IN
Toe-in: Inspection value

OUT 2 3 mm (OUT 0.08
1) Set the toe-in gauge in the position at wheel axis center height behind the right and left front tires.
2) Place a mark at the center of both left and right tires, and measure distance "A" between the marks.
3) Move the vehicle forward to rotate the tires 180°.
NOTE:
Be sure to rotate the tires in the forward direction.
4) Measure the distance "B" between the left and right marks.
Find toe-in using the following calculation:
A – B = Toe-in
B
6. REAR WHEEL TOE-IN
Refer to the FRONT WHEEL TOE-IN for rear toe-in inspection procedures. <Ref. to FS-10, FRONT WHEEL
TOE-IN, INSPECTION, Wheel Alignment.>
Toe-in: Inspection value
 
0 3 mm (0 0.12 in)
7. THRUST ANGLE
1) Park the vehicle on a level surface.
2) Move the vehicle 3 — 4 meters (10 — 13 feet) straight forward.
3) Draw the center of loci for both the front and rear axles.
4) Measure distance "L" between the center lines of the axle loci.
Wheel Alignment

0.12 in)
A
FS-00015
FS-10