Subaru S209 2019 Service Manual page 55

9) Disconnect the intercooler water spray front hose assembly from the intercooler water spray side hose as-
sembly.
10) Tie a string to the front hood side of the intercooler water spray front hose assembly, and pull it out to the
front fender side from the front hood.
NOTE:
Leave the string in the front hood or the front fender, and use it during installation.
11) After completely pulling out the intercooler water spray front hose assembly, remove the string tied to the
intercooler water spray front hose assembly in step 10).
12) Release the claws, and then remove the cover side sill - front INN LH.
CAUTION:
Do not pull with excessive force. Doing so may damage the claws of the cover side sill - front INN LH.
13) Remove the clips, and remove the cover side sill - front LH.
14) Remove the rear seat cushion assembly.
15) Release the clips and claws, and then remove the cover side sill - rear INN LH.
CAUTION:
Do not pull with excessive force. Doing so may damage the claws of the cover side sill - rear INN LH.
16) Remove the trim panel - center pillar LWR LH.
Intercooler Water Spray Hose
IN-25
INTAKE (INDUCTION)
AA-14025
AA-14026