Subaru S209 2019 Service Manual page 217

CAUTION:
Be sure to prepare a stopper; otherwise, the drill may interfere with the bumper face - rear and cause
damage.
(a) 5 mm (0.2 in)
(4) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (b) using a drill (a), and then
make a hole of 6 mm (0.24 in) diameter.
CAUTION:
Be sure to make a hole of a specified diameter. The rear quarter spoiler may not be installed if the
hole diameter is large.
(5) Insert a J nut (a) to the hole (c) created.
Rear Bumper
(a)
(b) Drill bit
(b)
(b)
(a)
EI-29
EXTERIOR/INTERIOR TRIM
(b)
(c)
(c) Adhesive tape
RH
Ft
AA-10027
UP
Rr
AA-10065