Subaru S209 2019 Service Manual page 209

• Be sure to make a hole of a specified diameter. The front under spoiler may not be installed if the
hole diameter is large.
(9) Remove the clip (a) on vehicle, and insert the well nuts (b) to the hole positions (c) on lower side of
the bumper face - front.
3) Install the front bumper extension.
(1) Clean and degrease the front bumper extension attachment area on the bumper face - front.
NOTE:
• When the ambient temperature is 15°C (59°F) or less, heat the entire part of double-sided tape and the at-
tachment area to approx. between 25°C and 40°C (77°F and 104°F) using a heat light, etc.
• Heating a particular small area will cause deformation of the parts.
Front Bumper
(b)
(c)
(c) (c)
(b)
EI-21
EXTERIOR/INTERIOR TRIM
(a)
Ft UP
RH
(c)
(c)
(c)
(c)
AA-10122
LH
(a)
AA-10047