EXTERIOR/INTERIOR TRIM
(2) Peel off the backing sheet (a) on the front bumper extension by 38.5 mm (1.52 in), and then remove
the whole backing sheet (b).
(a)
(3) Set the front bumper extension (f) to the bumper face - front, and temporarily install it with nut (b) and
screws (d) and (e).
CAUTION:
Screws are different in length. Be sure to check the length before installation.
(c)
(a)
Collar
(b)
Nut
(4) Remove the mud guard - front.
(5) Install the bumper face - front to the vehicle.
(6) Align the arch section of the front bumper extension to the position shown as dotted line (a).
Front Bumper
(b)
(a)
(a)
(a)
(a)
(f)
(b)
(e)
(c)
Washer
(d)
Screw (M4 × 8)
(a)
(a)
EI-22
(a)
AA-10033
(c)
(d)
AA-10034
(e)
Screw (M4 × 12)
(f)
Front bumper extension