8) Temporarily connect the pressure hose to feed pipe and return hose to return pipe. Temporarily tighten the
bolt of clamp E.
(1) Return hose
(2) Pressure hose
(3) Clamp E
(4) Return pipe
(5) Feed pipe
NOTE:
Make sure that the character "8" on each clamp is positioned on the opposite side, as shown in the figure.
(1)
(2)
(1) Clamp E
(2) Pressure hose
(3) Return hose
9) Tighten clamp E.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
10) Tighten the pressure hose to feed pipe and return hose to return pipe.
Tightening torque:
15 N·m (1.5 kgf-m, 11.1 ft-lb)
11) Connect pipes A and B to the four pipe joints of the gearbox.
Pipe Assembly
(3)
(1)
(2)
(4)
(5)
PS-00847
(3)
PS-01344
POWER ASSISTED SYSTEM (POWER STEERING)
PS-11