Subaru S209 2019 Service Manual page 245

CAUTION:
Attach the pattern paper along the arch section.
(a) Pattern paper RQ GARN
(b) Pattern paper RQ GARN
(8) Make mark-off lines for drilling holes (c) at 3 locations according to the pattern papers (a) and (b).
(a) Pattern paper RQ GARN
(9) Remove the pattern paper.
(10) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (f) using a drill (e), and then
make a pilot hole of 6 mm (0.24 in) diameter. Finally, make a hole of 9.5 mm (0.37 in) diameter.
CAUTION:
• Be sure to make a hole of a specified diameter. The rear quarter garnish may not be installed if the
hole diameter is large.
Side Garnish & Side Spoiler
(c)
(b)
(c)
(c)
(c) Masking tape
(b)
(b) Pattern paper RQ GARN
(c)
(a)
(c)
(c)
(d)
(c) (a)
(c)
(c)
EI-57
EXTERIOR/INTERIOR TRIM
AA-10150
(d) Alignment position for radius curve
end
AA-10151
(c) Mark-off line position