Subaru S209 2019 Service Manual page 138

REAR SUSPENSION
CAUTION:
While checking there is no dragging of harness and wire, lower it slowly with a transmission jack.
12) As necessary, remove each part from the rear sub frame assembly.
B: INSTALLATION
CAUTION:
• For parts which are not reusable, always use new parts.
• Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in
full contact with the ground.
• During the installation, make sure that the marking of ABS wheel speed sensor harness does not
twist.
1) Check the removed parts for wear, damage and crack, and repair or replace them if faulty.
2) Install each part to the rear sub frame assembly.
Tightening torque:
Refer to "COMPONENT" of "General Description" for the tightening torque.
3) Install the rear sub frame assembly.
(1) Lift the rear sub frame assembly using a transmission jack.
(2) Install the right and left supports - sub frame and the rear sub frame stopper lower.
CAUTION:
• The rear sub frame assembly is heavy. Make sure that it is horizontally-supported.
• While checking there is no dragging of harness and wire, raise it slowly with a transmission jack.
Rear Sub Frame
RS-10
AA-13021