ACCESSORIES 9-15
S W I T C H
N E L
F i q 9 . J D E l e c v o C l e à r F ê à r W i n d o w D e f o g g e ' . F ' M o d e l s
O N - C A R S E R V I C E
coNTRoL swlrcH
7- Reverse removal procedure for installation.
'4" and 'B' Mod€ls
R e p l â c ê m e n t ( F i g . g - i D a n d 9 - 2 D )
T I M E R
l. Remove the battery ground cable.
,.
2. R€âch up ùnder lower edge of instrument panel and
,A,,and,8"
MOdelS
3. Remove spriig clip secùring srvitch to instrument
panel
Replacem€nt (Figs. 9-1D, 9-2D)
4. Remove switch âssembly.
5. To install, reverse steps 1-4 above. Check switch
1' Remove timer from location ôn fuse block'
operation
2. Install new timer and check system operâtion, first
'F'
Models
startmg engne
Replac€m€nl (Fig. 9-3D)
L Disconnect battery ground câble.
"F' Models
2. Reach up under cluster left side and deprcss
headlamp switch shâft retainer bùtton, whil€ gently pulling
R6placom6nt (Fig. 9-3D)
3. Remove headlamp switch .etaining nùt.
L
R€move (2) screws retaining relay to IP
4. Remove (6) screws retaining bezel to LP.
reinforcement.
5. Pull bezel forward, disconnect cieârette lighter and
2. Disconûect widng and remove relay.
rear defog switch wi ng and remove bezel.
6. Remove rear defog switch retâining clip and rcmove
3. Instâll new timer and check system operâtion, first
switch.
stârting engine.