6C-78 FUEL SYSTEM
C H O K E
H O U S I N G
A T T A C H I N G
.scREw
Fig. 6C4 28' Bemoving Anerôid cavily Insert
On M4MC hot air choke model, it is not necessary to
remove bâme plate from beneâth the thermostatic coil.
Dhtortion of the thermostatic coil may result if forced off
the center retaining post on the choke cover.
2. Remov€ choke housing assembly from float bowl by
removing retaining screw and washer inside the choke
housing (Fig. 6C4-30). The complete choke assembly cân
be removed from the flôat bowl by sliding outlvârcl.
3. Remove secondary throttle valvelock-out lever from
float bowl (Fis. 6C4-31).
F i g 6 C 4 3 0 - B e m o v i n g c h o k e H o ! s i . g
4. Remove lower choke lever from inside floât bowl
cavity by inverting bowl.
5. Remove plastic tube seal from choke housing (Fig.
6C4-31).
NOTICE: Piastic tube seal should not be immersed in
carbur€tor cleaner.
6. To disassemble intermediate choke shaft from choke
housing, remove coil lever retaining screw at end of shâft
inside th€ choke housing (Fig. 6C4-30). Then remove
thermostatic coil lever from flâts on intermediâte choke
shaf!. Remove intermediate choke shaft from the choke
housing by sliding outward. The fêst idle cam can now be
removed from the intermediate choke shaft (Fig. 6C4-31).
C H E C K A À L L R E T A I N E R
PTASTIC
-
REAR VACUU,II
U B E S E A L
B R E A K T E V E R
S C R E W
SECONDÀRY FAST IOIE
IOCK OUI
CAM FOTLOIYFR
F i g 6 C 4 2 9 F l o a t B o w J e t s
F i g 6 C 4 - 3 1 . - C h ô k e H o û s i n 9 A s s e m b l y