Chevrolet CAMARO 1979 Service Manual page 186

2C-14 CHASSIS SHEET METAL
I g 2 C 2 5 q c d d t o S u p p o ' r r o F e n d e , S . i n A . V o o ê l
RADIATOR
F i s . 2 C - 2 7 - F e n d e r T o B a d i ô t o r S u p p o r t F - l v l o d e l
8. Rernove inner fender skirt to fender âttâching bolts.
9. R€mov€ the âttâching bolt ât reâr ând under the
fender.
10. Remove fender.
Rêmoval-L€ft Side
l. Remove the junction block ând ground wire.
2. Remove hom.
3. Remove heâder assembly from fender and bumper
4. Remove hinge bolt and support hood
5. Remove hood bracket ând hood stop bolt.
6. Remove feûder to radiator sùppon bolts,
7, Removehood releasecable at latch and remove from
fender.
8. Remove low€r molding screw.
9. Reniove inner fender skirt to fender attaching bolts.
10. Remove attâching bolts at reâr ând ùnder the
I I. Remove the fender.
Rgmoval . F, X Models
Disconnect battery ground cabl€. Also disconnect both
cables ând remove bâttery from v€hicle ifdghÈhand fender
l. Place vehicle on hoht and remove wheel.
2. Remove bumper (See Seciion 2B).
3. Remove hood with hinges from vehicle âs outlin€d
in this s€ction.
4. Disconnect header panel on models so equipped.
5. Remove fendff filler panels and bmces as necessâry.
6. Remove headlamp bezels and heâdlamps (See
Section 8).
7. Remove screws r€taining fender to radiator support,
F l s . 2 C . 2 6 - Ê â d i â t o r S ! p p o r t T o F e n d e r S k i | t F . M o d e i Fis. 2C-28-Êadiâtor Support To Fe.der Ski X-Model