Chevrolet CAMARO 1979 Service Manual page 745

ENGINE EXHAUST 6F.5
30 LBS, FT:
SEA
)\-
\,
\ , 2 '
N I F O L D
CATALYTIC
C O N V E R T É R
T J G H T E N T O
t 5 L A S . F T .
EXCEPT CALIF.
G H T E N T O
E X H A U S T
F i g . 6 F - l - E x h ê u s r C r o s s o v e r P i p e - L o
NOTICE: Do not pry fill plug from converter âs
damage to fill plug sealing surfâces could result.
CONVERTER
TRANSMISSION
F i 9 . 0 F - z - C â l a l y t i c C o n v e d e r - F ê n d x S e r i ê s
4. Clamp on vibrâtor and câtâlyst container (Fig 6F-
8). Use adapter J-25077-6 ifconverter was bùilt with pressed
pluc.
5. Disconnect âir supply to aspirator and connect air
supply to vibrator. Catalyst will noiv drâin from th€
converter into the empty contamer'
6. When âll the catalyst has been rcmoved from the
convefier, disconnect âh supply to vibrator ând remove
container from the converter,
7. Discard ùsed catalyst
Catalyst Replâcêm€nt
1. Fill container with approv€d replacement câtalyst.
2. Install fitl tube extension to the fixture (Fig. 6F 9).
Use adapier J-25077-6 if conv€rter was built with pressed
plug.
3, Connect arr supply to aspintor and vibrator,
4. Attach catalyst conlâiner to thefixture (Fig. 6F- 10).
5. After the catâlyst stops flowing, disconnect ar
supply to the vibraior.
6. Remove vibrato. and check that caialyst hâs filled
converier flùsh with fill plug hole. Add catalyst if r€qùired.