Chevrolet CAMARO 1979 Service Manual page 157

B U M P E F S
2e-7
Installâlion
Reverse removal procedure to instâll bumper and refer
to torque specificarions at rhe rear ofthis section for proper
_ Impact strips and bumper cushions caû be insralled by
pushing retaining prongs through cùt-outs in the bumpers
and bumper guards.
See Figure 28- to for correcl bumper atignfrenr.
Removal " Wâgons (Figs. 2B-14 and 2B-1S)
l. Raise the vehicl€.
2. Removetwo (2) screws connecting license ptatelâmp
ass€mbly to buûper ând tap€ assembly awây from bumpei
to prev€nt damage or interfercnce wh€n removing bumper
3. Support bumper assembly ând remove nuts from
reinforcement to en€rgy absorber and remove bumper
Fig. 2B- T3'.Bear Energy Absorbef
4, To disassemble bumpet proceed as folows:
. ^a. Remove _ lower bolts attâching fâce bar to
remrorc€menl and separate,
b. If equipped wirh bumper guârds they now may oe
removed from the face bar.
5. Ifthe energy âbsorber is to be r€moved (Fig. 2B-14)
proceed as foliows:
. .
a. R€move bolts connecting rear of energy absorber to
_ b. Remove bolt and r€rainer plate from fronr ofeneryy
absorber and remove from body.
Installation
Reverse removâl procedure ro install bumper and refer
to torque specifications ât the reaf ofrhis section for proper
See Fig. 28-16 for proper bunper alignmenr.
F i g 2 B - 1 2 , R e a r i m p â c t S t r i p s
I
F i g . 2 B . 1 4 B W a g o n A e a r B ! m p ê r