Rt Control (Realtime Control) - Korg M3 Parameter Manual

Audio Solo:
Panel-Switch Solo Mode On and MIX PLAY/MUTE
1–4 switches
Solo applies to oscillator, and the audio inputs. For more
information, please see "OSC Solo:" on page 310.
Exclusive Solo
For more information, please see "OSC Solo:" on page 310.
Audio Solo 1...4
This switches the Solo On/Off setting for each audio input.
Note: The Solo On/Off setting is not preserved when you
write.
Audio Volume:
MIX VOLUMES sliders 1...4
Audio Volume 1...4
This adjusts each audio input level.

RT Control (Realtime Control)

0–8e
Realtime Control lets you use the eight sliders to edit the
parameters of a oscillator or effect. The switches will control
the effect on/off status.
0–8d: RT Control
Selected Parameter information
When you select a Slider or Switch, this area shows detailed
information about its parameter assignments.
Effect On/Off:
Effect On/Off switches 1...8
These turn each effect on/off. The effect will be enabled if
this is on (LED lit).
IFX1...5, MFX1, 2, TFX
These turn each effect on/off.
Sampling P0: Recording RT Control (Realtime Control)
Realtime Control:
This will control the timbres of the global MIDI
channel.
Realtime Control sliders 1...8
Sliders 1–4 all have dedicated functions which correspond
to MIDI CCs. Sliders 5–8 can be assigned to a wide variety of
functions, many of which also have corresponding MIDI
CCs.
When you move a slider, it sends out the corresponding
[Play, Mute]
MIDI CC.
Most of these functions adjust (i.e., apply scaling to) various
oscillator settings. Unless otherwise noted, "scaling" means
that the parameters are at their programmed values when
the controller is at 64, at their minimum when the controller
is at 0, and at their maximum when the controller is at 127.
For another look at this, please see the diagram below.
CC parameter scaling
[000...127]
Parameter
As Programmed
0–8
Menu
Slider 1: Flt Fc (Cut Off)
This slider scales the cutoff frequencies of Filters A and B,
and transmits and receives MIDI CC #74.
Slider 2: Flt Reso (Resonance)
This slider scales the resonance of Filters A and B, and
transmits and receives MIDI CC #71.
Slider 3: Flt EG (Filter EG Intensity)
This slider scales the effect of the Filter EG on the cutoff
frequencies of Filters A and B. It also transmits and receives
MIDI CC#79.
Slider 4: EG Rel (EG Release)
This slider scales the release time of the Filter and Amp EGs,
and transmits and receives MIDI CC#72.
Slider 5–8
This is the current value of the slider and its MIDI CC.
You can set sliders 5–8 to a wide variety of modulation
functions, using the P4: Controllers– Setup page.
All of the settings also correspond to MIDI messages–
usually CCs.
[Off, On]
99
Value
00
0 64
CC Value
127
[000...127]
[000...127]
[000...127]
[000...127]
[000...127]
311